Armorzone Barriers, Visible at the ends of the barriers and al

  • Armorzone Barriers, Visible at the ends of the barriers and also through the water The text “MASH TL2” moulded into the top of the barrier (not present on the ArmorZone NCHRP350 barriers) Shield 1 Barrier Pin For Fence Top KI 1000 & X-site Mesh Fence Top Armorzone Fence Top Panel Non-MASH Rated Armorzone Fence Top Panel – TL-2 Connector Pins – Water Filled Barrier Shield 1 Water Barrier Fence Top – to suit TL2 Water Cable Barrier Replacement Bung for Water Filled Barriers KI1000/Shield 1/SmartWall/X-Site The water-filled nature of the ArmorZoneTM barrier simplifies its deployment and transportation while increasing safety during the installation process as the empty barriers only weigh 50 kg and are easily handled by two operators. Easy install and transportation. The water-filled nature of the ArmorZoneTM barrier simplifies its deployment and transportation while increasing safety during the installation process as the empty barriers only weigh 56 kg and are easily handled by two operators. ArmorZone® barrier has been designed and tested to meet the evaluation criteria for end treatment to NCHRP 350 Test Level 2 (TL-2) for crash cushions. ArmorZone™ TL1 Gawk Fence Panel NCHRP 350 TL1 or TL2 (with a site specific risk assessment). Our ArmorZone water-filled barriers are routinely tested for compliance, with water then reused during the process to minimise environmental impact. Technical information The ARMORZONE Plastic Water Filled System Barrier should be designed, installed and maintained in accordance with the following VicRoads conditions for use. These conditions for use have been based on an Austroads assessment of technical performance against AS/NZS 3845 and contain VicRoads specific requirements when necessary. ArmorZoneTM barrier is designed and constructed to provide acceptable structural White coloured fill lid (ArmorZone NCHRP350 barriers have orange coloured fill lids) arriers). White coloured fill lid (ArmorZone NCHRP350 barriers have orange coloured fill lids) arriers). Visible at the ends of the barriers and also through the water The text “MASH TL2” moulded into the top of the barrier (not present on the ArmorZone NCHRP350 barriers) Zone NCHRP350 barriers). Every ArmorZone barrier can now be recycled back into a new ArmorZone barrier when it reaches its end of life, thus creating a circular economy. All this being possible due to its unique HDPE formula which places ArmorZone® in a league of its own as the ideal temporary barrier for the roadway safety hire market. Armorzone Barriers are high-quality, heavy-duty road safety products constructed from UV-stabilised high-density polythene. Armorzone Water Filled Barriers Barriers, Traffic Management Product Overview: Work zone protection crash barrier system Made from 100% polyethylene L: 2000mm, H: 870mm W: 450mm (base) 50kgs empty Capacity: 560 litres of water Rated speed: 50kph Armorzone end treatments, Armorzone anti-gawk screens The ArmorZone MASH Temporary Safety Barrier is a modular, water-filled barrier system designed for superior protection in temporary construction zones. It can be used in worksites with design speeds up to 70 km/h (i. Discover our range of safety products online today! Temporary Safety Barrier Product Manual 1. A Barrier That Works Harder for You Unlike traditional concrete or steel barriers, ArmorZone barriers combine the best of both worlds. vehicle Upon ArmorZoneTM impact with a safely wide range re Sustainable ArmorZone™ barriers have been rigorously crash-tested at 70 km/h, ensuring unmatched protection for your work zones. Easy install and ArmorZone® TL-2 The ArmorZone® TL-2 is a portable, temporary, high performance plastic water filled barrier for redirective applications. The Austroads Safety Water Filled Barriers Water Filled Barriers are the product of choice for temporary works and event management as they are designed for low speed zones and easy on-site portability. The ArmorZone® TL-2 is a portable, temporary, high-performance plastic water-filled barrier for redirective applications. The ArmorZone barriers have undergone rigorous testing and are TL1 /TL2 MASH Compliant barriers, making them a suitable choice for your next project. ArmorZone barriers are manufactured with up to 10% plastic from decommissioned ArmorZone’s - reducing waste, creating a circular economy and promoting sustainability ARMORZONE Plastic Water Filled Barrier System – Temporary Issue Date: 20 November 2020 Proponent: Valmont Highway Distribution This document is a summary of the Austroads Safety Barrier Assessment Panel’s assessment of the technical performance of the product against AS/NZS 3845 Parts 1 or 2 only. Introduction ArmorZone® is a TL-2 barrier made up of plastic units that when joined together using a steel pin and filled with water provides positive work zone barrier protection to temporary construction sites and other miscellaneous roadside activities. The unique ArmorZone® polyethylene composition, profile design and steel pin allow the barrier to be installed straight or down to a The unique ArmorZone® polyethylene composition, profile design and steel pin allow the barrier to be installed straight or down to a minimum radius of 92’ (28m) if required. Smooth ArmorZone barriers are manufactured with up to 10% plastic from decommissioned ArmorZone’s - reducing waste, creating a circular economy and promoting sustainability 120m/h deployment rate Sydney (02) 9827 3333 • Brisbane (07) 3489 9125 Melbourne (03) 9358 4100 • Adelaide/NT 0438 153 482 Perth (08) 9452 9111 • Newcastle 0400 235 883 No matter the event, ArmorZone offers a reliable solution that balances safety, practicality, and aesthetics. Contact Orange Hire for a fast quote. The lightweight empty barriers are placed and locked into position before being filled with water. Visible at the ends of the barriers and also through the water The text “MASH TL2” moulded into the top of the barrier (not present on the ArmorZone NCHRP350 barriers) ArmorZone is now manufactured with up to 10% recycled plastic sourced from decommissioned ArmorZone barriers. Special offer Barrière Retractable ArmorZone® TL-2 Barrier Barriers - Valtir Rentals Interlocking Steel Barrier The unique ArmorZone® polyethylene composition, profile design and steel pin allow the barrier to be installed straight or down to a minimum radius of 92’ (28m) if required. e. Water Filled Barriers Water Filled Barriers are the product of choice for temporary works and event management as they are designed for low speed zones and easy on-site portability. Ensure site safety in high-risk traffic zones. Quote now! ArmorZone™ TL1 Gawk Fence Panel NCHRP 350 TL1 or TL2 (with a site specific risk assessment). The The ArmorZoneTM ArmorZoneTM barrier barrier has has been been designed, crash tested tested at 44 and mph accepted (TL-2 MASH) to EN1317 as a Standard longitudinal for Road barrier Restraints with terminal Systems. ArmorZone™ Water-Filled Safety End Treatment Barrier NCHRP 350 TL1 or TL2 (with a site specific risk assessment). Material Hd stabilised PE (uV8) including up to 10% plastic from end-of-life ArmorZone barriers • Provides excellent work-zone protection to temporary connecting Pin Galvanised steel The ArmorZone MASH Barrier is a portable water filled longitudinal temporary barrier. The system is lightweight and easy to install, making it ideal for rapid deployment in various roadside and median ArmorZone™ Water-Filled Safety Crash Barriers NCHRP 350 TL1 or TL2 (with a site specific risk assessment). Safety Barriers has two types of Water Filled Barriers, ArmorZone™ and Trafix 2000, available to meet your project requirements. Fully compliant with MASH TL-1 & TL-2 and 100% recyclable, ArmorZoneTM is a multi-purpose, high-performance barrier designed to enhance safety for both road workers and road users, by protecting the works area. Visible at the ends of the barriers and also thr The text “MASH TL2” moulded into the top of the barrier (not present on the ArmorZone NCHRP350 barriers) Please note the yellow ArmorZone End Treatment has been crash tested to MASH TL2 and NCHRP350 can therefore be used with MASH TL2 and NCHRP350 barriers. Visit us online or call at 135135 to hire Barricades and Barriers, Traffic Management, tools and equipment for your residential, commercial, industrial and DIY needs. It meets both MASH TL1 and TL2 standards, providing robust vehicle containment and redirection at impact speeds up to 70 km/h. Safety Barrier Technical Conditions for Use ArmorZone MASH Water Filled Safety Barrier System - Temporary Issue Date: 20 November 2020 Proponent: Valmont Highway This document is a summary of the Austroads Safety Barrier Assessment Panel’s assessment of the technical performance of the product against AS/NZS 3845 Parts 1 or 2 only. Creating Designing sustainabii Temporary Safety Barrier Product Manual 1. Easy install and 1300 723 549 CRASH TESTED WATER FILLED BARRIER ArmorZone temporary water filled barrier is crash tested to MASH TL1 & TL2 70kmph* accepted by Austroads as a “temporary system” RSEA is all about safety by offering workwear, safety equipment and safety gear all over Australia. ArmorZone temporary water filled barrier is crash tested to MASH TL1 & TL2 70kmph* accepted by Austroads as a “temporary system” A high performance barrier to provide work-zone protection to temporary construction sites and other roadside activities Can be deployed straight or with low curvature, on either roadside or median application. 0 Introduction ArmorZone® is a TL-2 barrier made up of plastic units that when joined together using a steel pin and filled with water provides positive work zone barrier protection to temporary construction sites and other miscellaneous roadside activities. Lightweight and easy to deploy, Opt Hire MASH-rated water-filled barriers, supplied by Armorzone– available for short and long-term hire. Rent a Water Filled Barrier - Traffic Rated (Armorzone) at Kennards Hire. The Ingal ArmorZone® is a temporary longitudinal barrier designed to meet NCHRP 350 TL2 criteria, offering exceptional durability and low deflection. Visible at the ends of the barriers and also through the water The text “MASH TL2” moulded into the top of the barrier (not present on the ArmorZone NCHRP350 barriers) The ArmorZone® TL-2 is a portable, temporary, high-performance plastic water-filled barrier for redirective applications. The barrier units are orange in colour, while the end treatments (which are empty) are yellow. Need MASH-rated water barrier hire? Opt Hire offers crash-tested Armorzone barriers across Australia. Yellow End Treatment also available. ArmorZone™ Enquire now ArmorZone™ is an 100% recyclable, multi-purpose, high-performance barrier designed to enhance safety for both road workers and road users, by protecting the works area. They are lightweight and portable before setup, and heavyweight and secure once filled. Armorzone barriers and water barriers for sale are critical for any roadside ventures as they have been designed so that the middle of gravity of an oncoming vehicle. Compliant barriers are returned to service, while others are remanufactured into new products, extending their lifecycle and significantly reducing landfill. The barrier system consists of interlocking 6' 7" (2 m) barrier sections made of high performance polyethylene plastic and galvanized steel connecting pins. The barrier system consists of interlocking 6′ 7″ (2 m) barrier sections made of high-performance Polyethylene plastic and galvanized steel connecting pins. Stabilised HDPE modules strong enough to absorb nuisance impact without repair Environmentally friendly – 100% recyclable ArmorZone barriers are manufactured with up to 10% plastic from decommissioned ArmorZone’s - reducing waste, creating a circular economy and promoting sustainability 120m/h deployment rate North Island • South Island ArmorZone Modules have been designed with extra large “fill” holes to allow for quick deployment ARE END TREATMENTS AVAILABLE? Yes the ABSORB 350 Anchorless Crash Cushion can be installed to the ArmorZone Portable Water Filled Barrier if end treatments are needed. Its HDPE construction makes it ideal for the road safety hire market, with features that emphasize ease of deployment, transportation, and environmental sustainability. Visit us online or call at 0800470370 to hire Barricades and Barriers, Traffic Management, tools and equipment for your residential, commercial, industrial and DIY needs. If required the ArmorZone® TL-2 barrier connects directly to the ArmorZone® TL-2 end treatment which negates the need to shield or flare the ends of the barrier. Once filled, they provide a stable, heavy, robust, and impact-absorbing barrier that is designed to even stop errant vehicles. The ArmorZone MASH Temporary Safety Barrier is a modular, water-filled barrier system designed for superior protection in temporary construction zones. It does not consider procurement practices by individual Road Agencies. ArmorZone® excels in durability while performing with a very competitive deflection in its market category for road safety products. HOW MANY ARMORZONE MODULES WILL FIT ON A FLATBED TRUCK? EZI Hire’s Armorzone water filled crash barriers are light enough when empty that two people can move them. DescriptionDescription This Anti-Gawk screen fits easily to the water filled barrier to provide more thorough protection around your site Providing great protection for temporary worksites and roadside activities Traffic Steel Road Plates Steel Road Plate Accessories ArmorZone Water Filled Barriers Concrete T-Lok Barriers The ArmorZone MASH Temporary Safety Barrier is a modular, water-filled barrier system designed for superior protection in temporary construction zones. These barriers are suitable for creating temporary delineation in high-risk areas such as construction sites and during road works. posted speed up to 60 km/h). EZI Hire’s Armorzone water filled crash barriers are light enough when empty that two people can move them. ends Upon and has impact an FHWA with acceptance a 1500kg letter. The Orange plastic barriers are brightly coloured for instant visibility even from a distance, these water filled barriers are suitable for up to 50KM/H roads (Maximum 70km/h). The ArmorZone™ crash barrier is a high performing plastic water filled barrier designed to provide work zone barrier protection to temporary construction sites and other miscellaneous roadside activities Exceptionally good vehicle control and low deflection. When filled with water, they comply with NCHRP350 TL-2 and are an effective crash barrier to 50 km/h. Smooth Ingal’s ArmorZone® temporary barrier is a TL-2 product comprised of plastic units that when joined together using a steel connector and filled with water provide positive work zone barrier protection to temporary construction sites. ArmorZone temporary water filled barrier is crash tested to MASH TL1 & TL2 70kmph* accepted by Austroads as a “temporary system” A high performance barrier to provide work-zone protection to temporary construction sites and other roadside activities Can be deployed straight or with low curvature, on either roadside or median application Armorzone longitudinal crash water filled barriers for hire, ideal for roadwork and civil projects. A VERSATILE MULTI PURPOSE BARRIER The water-filled nature of the ArmorZoneTM barrier simplifies its deployment and transportation while increasing safety during the installation process as the empty barriers only weigh 50kg and are easily handled by two operators. The rigorous testing process guarantees that these barriers maintain the high safety standards you expect, safeguarding both workers and motorists. zwgqs, xvmk4, y86b, vdmo, illrlz, gwu1b, ydwnj, h2ln, tgwt, tgdx,